Verint NEXTIVA S2800E series Guida Utente Scaricare il pdf (Pagina 23)

Nextiva S2800e Series User Guide

Verint Video Intelligence Solutions 15

4. Unlatch the interface board and swing it 90º downward, providing access to the

terminal blocks. To completely remove the board, snap it out of the hinge after its

rotation to the 90º downward position.

5. If you are not using a flexible conduit pipe:

a. Remove the conduit fitting by loosening the nut and sliding it out.

b. Install the supplied strain relief fitting in its place.

c. Hold the enclosure near the ceiling hole and route cables through the strain relief

fitting.

6. If cables are channeled through a flexible conduit pipe:

a. Hold the enclosure near the ceiling hole and route the cables through the conduit

fitting.

b. Insert the end of the flexible conduit pipe into the conduit fitting. Cable length

should be flush with the bottom of the enclosure, approximately 9 inches

(229 mm).

c. Tighten the clamp screw.

7. Lift the enclosure up through the ceiling hole, turn it, then tighten the flipper screws.

8. Connect the wires to the interface board. For the procedure, see page 24.

To install the in-ceiling camera:

1. If you are not using a flexible conduit pipe:

a. Loosen the flipper screws and remove the enclosure from the ceiling.

b. Slide the cables back through the fitting until the terminal blocks are flush with the

bottom of enclosure, approximately 9 inches (229 mm).

c. Tighten the conduit fitting and reinstall the enclosure into the ceiling by tightening

the flippers.

Note: Ensure to leave minimal wire slack at all connection points.

Latch

Hinge

Interface board

Conduit fitting

Nextiva S2800e Series User Guide.book Page 15 Wednesday, March 11, 2009 3:20 PM

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 70 71

Nessun commento

Verint NEXTIVA S2800E series Guida Utente Pagina 23