Verint NEXTIVA S2800E series Guida Utente Scaricare il pdf (Pagina 30)

24 • Supported Protocols Nextiva S2800e Series Programming Guide

Testing Conditions

Pelco: Tested with the MPT9500 Controller and Pelco D protocol. S2800e should function with any

Pelco keypad using Pelco D protocol.

Kalatel: Tested with KTD-404, which requires a protocol converter KTD-410 to convert Kalatel’s

Digiplex protocol to ASCII RS-232 protocol; an RS-232 to RS-422 converter (with external

power) is then required to connect the S2800e. The S2800e in Kalatel mode is simplex 9600,

n, 8, 1. S2800e should function with any Kalatel keypad using Digiplex protocol.

Panasonic: Tested with WV-CU161 keypad, which does not require any port adapters. For detailed

information refer to Panasonic keypad user manual connection diagram. Set keypad

communication protocol to RS-485: 9600 baud, duplex, data bit 8, parity NONE, and stop bit

1. S2800e should function with most Panasonic keypads that use Panasonic WV-CS850(A)

ver 3.0 protocol. (Version of the supported protocol: Panasonic WV-CS850(A) ver 3.0,

release date October 2001.)

Philips: Tested with LTC-5136 series keypad, which requires Bosch LTC 8557 series and Qlty ICC-

11 converters (both converters must be self powered) to resample the signal from RS-232 to

RS-422 protocol. For detailed information refer to Philips keypad user manual and converters

user manuals. To enable the Philips protocol, set S2800e SW2 DIP switch 7 to ON position.

Switches 2-6 and 8 must be set to OFF. Communication with the S2800e using Philips

protocol is supported at RS-422: 9600 baud, data bit 8, parity NONE, and stop bit is 1.

S2800e should function with most Philips keypads using Philips AutoDome TC8560/TC700

protocol. (Version of the supported protocol: Philips AutoDome TC8560/TC700 Series

Release Date: March 2000.)

Note: All companies make changes and improvements in their products. Because this product can interface

with equipment not manufactured by Vicon, there is a possibility that the interface protocols may have

changed since Vicon tested this product with the interfacing equipment. Vicon recommends purchasing

a single unit for bench testing prior to purchasing and installing this product in quantity.

The S2800e is designed to store PTZ preset locations on the internal memory. Certain manufacturers’

controllers are designed to store PTZ preset locations in the controller. Therefore preset functionality in the

S2800e dome will not work correctly with these types of controllers.

1 2 ... 25 26 27 28 29 30 31 32 33 34

Nessun commento

Verint NEXTIVA S2800E series Guida Utente Pagina 30